Clarke CHT403 Manuale di istruzioni per l'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Strumenti Clarke CHT403. Clarke CHT403 8. Carpet knee kicker

METHOD OF USE

1. Set the teeth to a depth to suit the

carpet thickness, as described

previously.

2. Kneel close to one corner of the

longest edge of the carpet and

place the kicker about 25 mm from

the edge of the gripper rail and

facing the skirting board.

3. Sink the teeth into the carpet and

apply reasonable downward

pressure on the handle-grip.

4. Use your knee to 'kick' the padded end of the kicker so as to jog the

carpet forward, whilst pushing down on the edge of the carpet so that it is

held by the carpet gripper

5. Work your way along this edge repeating the operation, then cut and

tuck the carpet edge between the gripper rail and skirting board.

6. Repeat along the opposite edge of the carpet other edges as required.

7. If in doubt about the fitting procedure please contact an experienced

fitter.

The only maintenance required is to ensure that after use, any carpet pile

that may have attached itself to the gripper pad is completely removed, and

the Kicker is stored with the grippers teeth protection cover in place.

Gripper teeth and Gripper Blade pad assemblies are available from your

CLARKE dealer - please see 'SPARE PARTS' for details.

RENEWING A GRIPPER PAD ASSEMBLY

Two gripper blade pad assemblies are each secured in place with two

screws.

Firstly, remove each Gripper Blade Pad assembly as follows:

1. Turn the teeth setting knob fully clockwise so that the teeth are fully

retracted.

2. Undo the two screws using a cross-head screwdriver.

3. Lift off the assembly.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]