CTS HES-3106 Series Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Interruttore CTS HES-3106 Series. CTS HES-3106 Series 13. 6 ports 10/100/1000base-t managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink management ethernet switch with

Stampa la pagina

2.3 Installing the Managed Switch

CAUTION

To prevent any damage or failure of the Managed Switch, please DO NOT

block the ventilation FAN holes.

Use the following guidelines when choosing a place to install the Switch:

 Firm and steady flat surface.

 The location of power outlet should not be far away from the device.

 Make sure that there is proper heat dissipation from and adequate

ventilation around the switch. Do not place heavy objects on the

Managed Switch.

 Make sure water and moisture cannot enter the case.

 Keep the cabling away from electrical noise.

2.4 Powering ON

The Managed Switch can be used with AC power adapter 100-240 VAC Input

and 12VDC output. The input connector is located on the left panel of the

Managed Switch. Before turning on the Managed Switch, please make sure that

network cables and power cables are securely connected.

Procedures:

1. Plug one end of the power adaptor into the power jack on the left

panel.

2. Plug the other end of the power adaptor into the power outlet. After

the power is on, the Power LED indicator should light in green.

Power Failure

In the event of power failure, unplug the power that is plugged into the switch at

the left of the device. When power is resumed, plug the power back to the switch.

Please note that the Managed Switch has no Power ON/OFF Button. Therefore,

the only way to power on or power off the switch is to connect or disconnect the

power adaptor.