CTS HES-3106 Series Kullanıcı Kılavuzu - Sayfa 9
Anahtar CTS HES-3106 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CTS HES-3106 Series 13 sayfaları. 6 ports 10/100/1000base-t managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink managed ethernet switch; 5 ports 10/100/1000base-t and 1 port 1000base-x or 100/1000base-x uplink management ethernet switch with
Sayfayı Yazdır
2.3 Installing the Managed Switch
CAUTION
To prevent any damage or failure of the Managed Switch, please DO NOT
block the ventilation FAN holes.
Use the following guidelines when choosing a place to install the Switch:
Firm and steady flat surface.
The location of power outlet should not be far away from the device.
Make sure that there is proper heat dissipation from and adequate
ventilation around the switch. Do not place heavy objects on the
Managed Switch.
Make sure water and moisture cannot enter the case.
Keep the cabling away from electrical noise.
2.4 Powering ON
The Managed Switch can be used with AC power adapter 100-240 VAC Input
and 12VDC output. The input connector is located on the left panel of the
Managed Switch. Before turning on the Managed Switch, please make sure that
network cables and power cables are securely connected.
Procedures:
1. Plug one end of the power adaptor into the power jack on the left
panel.
2. Plug the other end of the power adaptor into the power outlet. After
the power is on, the Power LED indicator should light in green.
Power Failure
In the event of power failure, unplug the power that is plugged into the switch at
the left of the device. When power is resumed, plug the power back to the switch.
Please note that the Managed Switch has no Power ON/OFF Button. Therefore,
the only way to power on or power off the switch is to connect or disconnect the
power adaptor.
9