Cub Cadet 190-356-100 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Spazzaneve Cub Cadet 190-356-100. Cub Cadet 190-356-100 12. 48" tiller attachments

Stampa la pagina

DETACHING TILLER

FIG X With tractor engine stopped and ignition key re-

moved. place wood blocks (1) under frame assembly as

shown to prevent tiller from tipping over when disconnected

from tractor 3-point hitch

(2).

Remove top link pin (3) and

nairpin cotter (4) and reinstall on tractor 3-point nitch. Dis-

connect telescoping PTO (5) by pushing locking collar

forward and pulling FTO aft. Next. disconnect lower link pins

(8) and hairpin cotters

(7)

and relnl.all an tiller for future

use. Drive slowly away from tiller.

FlG_ X

STORAGE

The followinG storage tips should be

~rlormed

at the end

each tilling seuon to

provi~e

!::::;3r

:lind most efficient

Jervice from the tiller.

1. Remove tiller from tractor using procedure in this manual

(Su Oetaching Tiller Section).

2. Thoroughly clean the tiller and remove all material that

may have built up under the shroud and on the tin

...

3. Remove the external drive chain and clean thoroughly

with cleaning solvent or diesel fuel. Sutlmerve chain in clean

oil, allow it to drain completely. then re-install on ""er.

Remove rust from any exposed metal and cover the are ..

with paint as necessary. Replace

any

damaGed or Ia.t "CAIJ-

TION" dacals.

5. Lutlrica:e tiller .. recommended in the lubrtcation MCtlon

of this manual.

S. Lightly oil

mOvtna

pat18,

inctudtng U".. to prevent ruatlng.

TIghten all

100. balta. T1ne

""';ning

bcHta

should

torqued to SO-55 toot poundl.

Siore tiller in a dry

piece.

MAINTENANCE

CAUTION

Sefore making any adjustments, disen-

gage PTO. shut off engine. lower tiller to

ground.

(make sure tines have stopped). and remove ign i-

tion

key.

FIG. XI -

Outer Chain Drive AdJultment

Remove the ;tis" x

V2"

nex bolts (1) holding the outer

shield (2) in

place.

Loosen the chain idler adjusting bolt (3)

and move the idler (4) toward the chain until the chain nas

~proximately

V."

movement at center. Retighten adjusting

bolt and check chain tension. IMPORTANT -

Da nat o"er-

",,,tan bolt. Reinstall outer shield.

•

FIG. XI

Ie·

MOVIMI!NT

AfITIR ADJUSTMI!NT

FIG. XII -

Aeplacln, Out.r Chain Drive

Remove the

~I"

x 'h" hex bolts holding the outer chain

drive shield (Aefer to

F19.

XI). Loosen chain idler adjusting

bolt (1) and move idler (2) away trom chain. Detach master

link (3) and remove chaJn. Replace with new Roller Chain.

adlust tension as in Fl90

XI,

and replace shield.

F1G. XII