Cub Cadet 190-356-100 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Spazzaneve Cub Cadet 190-356-100. Cub Cadet 190-356-100 12. 48" tiller attachments
Stampa la paginaTROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTION
Insuttlcient traction
Whee4 weights and/or cleat
Install one or !WO wheel weights to
(wh . . ls skid).
tread tires not installed.
eacn rear wheel and use cleat tread
.
tires or chains on turl tires •
PTO drive belt(s) slipping.
Adlust belt tension (See adlustment
section in your tractor manual).
Tln_ do not rotat ••
Torqu. Umlt.r sUpping
Adjust (Se. page 11).
.xc ... ively.
Ma •• ria' wrapped around tin.
Remove materia' wrapped or wedged
shaft (Rock or stump wedged
around shaft.
betw . . n tine and housing).
Chains climb
sproc~et
t . . th.
Adjust chain tension
(S . . page 10/11).
Ground too hard.
Set tiller depth for shalJow penetration,
then deepen progressively.
Ground too wet (Dirt and
Postpone tilling (See page 5 for
weeds on tin. snaft).
proper soil condition).
Tln_ rotate but ttl ....
TIn . . do not dig.
Cutting edge of tines mast b.
do. not till.
instaUed toward direction of rotation
(S . . page 11).
TaU gr ... or weeds wind
Cut, bum or defoliate long materia'
on tin ...
prior to tilling.
TIller cUmba out of ground
Till at a shallower depth -
add wheej
and propel. tractor forward.
weights to tractor. Tractor Uft should
b. in
"Float"
position.
TIne shaft rotat •• with clutch
PTO belt clutch improperly ad lusted.
diungaged-
(S . . adjustment section for your
tractor).
Mat.rlal wrapped on
Remove foreign materials from the
tln . . /shatt.
tine shaft.
Erratic operat.on of
tI ....
TIn. shaft out of balance. Replace
an, brokan tin ... (See pag.11).
nne shaft j.rb (rotat ..
Torqu. Iimlt.r discs wom out. S . .
erratIca'Iy).
your d .... r for
semce.
Torqu. limit.' spring pressure
Incorrecc (S . . page 11)
Tractor hitch adlusted for
Readjust lower
link
arms on tractor
T1II.r noisy/vibrat ..
axcnaive transport height -
hitch for not more than 16" of
excnaiv.l, in transport
PTO snaft at undesirable
clearance. (Measured from ground to
position.
angl ••
center of lower link pins with hitch in
"UP" position).
.