3D Hobby Shop YAK55 Manuale di montaggio - Pagina 14

Sfoglia online o scarica il pdf Manuale di montaggio per Giocattolo 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19.

-- Slide the horn through and center it to get an idea as to where it sits, slide out, add thick CA to the center of the horn

(make sure to get CA into the holes) on both sides and slide back in making sure it's centered properly before the glue

cures. Once in place, put a few drops of thin CA around the horn on each side.

-- Please examine the following pull-pull diagram closely

-- When attaching the servo connectors to the arm, do not tighten the nut fully, but leave it a bit loose so the connectors

can rotate freely. Use a drop of CA glue on the nut to prevent it from loosening in flight.

-- Start by attaching the cables to the pull-wire end. Crimp well, preferably by making creases in the crimp tube with

sharp pliers or cutters, rather than smashing it completely flat. Apply a drop of thin ca to the completed crimp to prevent

it from sliding on the cable.