3D Hobby Shop YAK55 조립 설명서 - 페이지 14

{카테고리_이름} 3D Hobby Shop YAK55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop YAK55 19 페이지.

-- Slide the horn through and center it to get an idea as to where it sits, slide out, add thick CA to the center of the horn

(make sure to get CA into the holes) on both sides and slide back in making sure it's centered properly before the glue

cures. Once in place, put a few drops of thin CA around the horn on each side.

-- Please examine the following pull-pull diagram closely

-- When attaching the servo connectors to the arm, do not tighten the nut fully, but leave it a bit loose so the connectors

can rotate freely. Use a drop of CA glue on the nut to prevent it from loosening in flight.

-- Start by attaching the cables to the pull-wire end. Crimp well, preferably by making creases in the crimp tube with

sharp pliers or cutters, rather than smashing it completely flat. Apply a drop of thin ca to the completed crimp to prevent

it from sliding on the cable.