3D Systems CUBE Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Stampanti 3D 3D Systems CUBE. 3D Systems CUBE 20. Replacing the print tip
Anche per 3D Systems CUBE: Documentazione (8 pagine), Lesson (15 pagine)
Stampa la pagina
and to be used mainly at home and it can be used in all areas.
This equipment conforms with International Electric Committee (IEC) 60950-1 and
meets the requirements of the applicable EC directives.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Important Safety Information
Safety Symbols and Definitions
HOT SURFACE HAZARD: A HOT SURFACE IS ACCESSIBLE IN THE
VICINITY OF THIS SIGN OR AT THE PRINT JET. AVOID CONTACT WITH
THESE AREAS. HOT SURFACES CAN CAUSE SEVERE BURNS.
Caution: Indicates something may happen that could cause loss of data,
damage to equipment, or could cause personal injury.
Caution: Indicates a pinch point hazard that could cause personal injury.
SHOCK WARNING: INDICATES A POTENTIAL SHOCK HAZARD.
Safety Guidelines
Follow all safety rules in this section and observe all cautions and warnings in this
guide.
DO NOT modify any safety features or make modifications to the Cube. Doing so is
prohibited and voids the manufacturer's warranty.