3D Systems CUBE Kullanıcı Kılavuzu - Sayfa 3

3D Yazıcılar 3D Systems CUBE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3D Systems CUBE 20 sayfaları. Replacing the print tip
Ayrıca 3D Systems CUBE için: Dokümantasyon (8 sayfalar), Ders (15 sayfalar)

Sayfayı Yazdır

and to be used mainly at home and it can be used in all areas.

This equipment conforms with International Electric Committee (IEC) 60950-1 and

meets the requirements of the applicable EC directives.

CAN ICES-3 (B)/NMB-3(B)

This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux

appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de

l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage

est susceptible d'en compromettre le fonctionnement.

Important Safety Information

Safety Symbols and Deﬁnitions

HOT SURFACE HAZARD: A HOT SURFACE IS ACCESSIBLE IN THE

VICINITY OF THIS SIGN OR AT THE PRINT JET. AVOID CONTACT WITH

THESE AREAS. HOT SURFACES CAN CAUSE SEVERE BURNS.

Caution: Indicates something may happen that could cause loss of data,

damage to equipment, or could cause personal injury.

Caution: Indicates a pinch point hazard that could cause personal injury.

SHOCK WARNING: INDICATES A POTENTIAL SHOCK HAZARD.

Safety Guidelines

Follow all safety rules in this section and observe all cautions and warnings in this

guide.

DO NOT modify any safety features or make modiﬁcations to the Cube. Doing so is

prohibited and voids the manufacturer's warranty.