3D Systems CubeX Sostituzione della punta di stampa - Pagina 7
Sfoglia online o scarica il pdf Sostituzione della punta di stampa per Stampanti 3D 3D Systems CubeX. 3D Systems CubeX 7.
Stampa la paginaSlowly raise the print pad until the print tip is touching it.
5
Continue raising the print pad until there is approximately 0.5mm between the print pad and the CubeX
wiping stick.
6
Turn the CubeX printer off and unplug it from the mains power supply.
7
Using the 2.5mm hex driver, tighten the print tip holding bolt (pictured) to lock the print jet in place.
8
With the print tip fastened you can now turn on the CubeX printer and start printing.