3D Systems CubeX 인쇄 팁 교체 - 페이지 7
{카테고리_이름} 3D Systems CubeX에 대한 인쇄 팁 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubeX 7 페이지.
페이지 인쇄Slowly raise the print pad until the print tip is touching it.
5
Continue raising the print pad until there is approximately 0.5mm between the print pad and the CubeX
wiping stick.
6
Turn the CubeX printer off and unplug it from the mains power supply.
7
Using the 2.5mm hex driver, tighten the print tip holding bolt (pictured) to lock the print jet in place.
8
With the print tip fastened you can now turn on the CubeX printer and start printing.