3D Systems CubeX Trio Sostituzione della punta di stampa - Pagina 3

Sfoglia online o scarica il pdf Sostituzione della punta di stampa per Stampanti 3D 3D Systems CubeX Trio. 3D Systems CubeX Trio 7.

Stampa la pagina
Unplug the print tip from the Print jet sensor board and feed the wire down the hole to the print tip.
3
Unfasten the print tip holding bolt.
4
The print tip and print jet are assembled by sliding the print tip into the print jet and twisting it (as
pictured).
5
To remove the print jet you will need to twist it and pull down, eventually you will find the correct
orientation and the print tip should easily slide out.