3D Systems CubeX Trio 인쇄 팁 교체 - 페이지 3
{카테고리_이름} 3D Systems CubeX Trio에 대한 인쇄 팁 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubeX Trio 7 페이지.
페이지 인쇄Unplug the print tip from the Print jet sensor board and feed the wire down the hole to the print tip.
3
Unfasten the print tip holding bolt.
4
The print tip and print jet are assembled by sliding the print tip into the print jet and twisting it (as
pictured).
5
To remove the print jet you will need to twist it and pull down, eventually you will find the correct
orientation and the print tip should easily slide out.