3D Systems CubeX Trio 인쇄 팁 교체 - 페이지 4

{카테고리_이름} 3D Systems CubeX Trio에 대한 인쇄 팁 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubeX Trio 7 페이지.

INSTALLING THE NEW PRINT TIP

Feed the print tip wires up through the print jet carriage and plug them into the Print Jet sensor board.

Slide the new print tip into the print jet and turn it until the print tip wires are orientated to travel straight up

to the Print Jet sensor board.

LEVELING THE PRINT TIPS FOR CUBEX DUO/TRIO

For a single print jet please see

Fastening the print tip on a

CubeX.

Power on the CubeX printer.

To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode. Heat all of the print jets

EXCEPT for the new one to 230° and clean of any plastic debris with pliers. Allow the Print Jets to cool

down.