3D Systems CubeX Trio Austausch der Druckspitze - Seite 4

Blättern Sie online oder laden Sie pdf Austausch der Druckspitze für 3D-Drucker 3D Systems CubeX Trio herunter. 3D Systems CubeX Trio 7 Seiten.

INSTALLING THE NEW PRINT TIP

Feed the print tip wires up through the print jet carriage and plug them into the Print Jet sensor board.

Slide the new print tip into the print jet and turn it until the print tip wires are orientated to travel straight up

to the Print Jet sensor board.

LEVELING THE PRINT TIPS FOR CUBEX DUO/TRIO

For a single print jet please see

Fastening the print tip on a

CubeX.

Power on the CubeX printer.

To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode. Heat all of the print jets

EXCEPT for the new one to 230° and clean of any plastic debris with pliers. Allow the Print Jets to cool

down.