3D Systems CubeX Trio Substituição da ponta de impressão - Página 4
Procurar online ou descarregar pdf Substituição da ponta de impressão para Impressoras 3D 3D Systems CubeX Trio. 3D Systems CubeX Trio 7 páginas.
Imprimir páginaINSTALLING THE NEW PRINT TIP
1
Feed the print tip wires up through the print jet carriage and plug them into the Print Jet sensor board.
2
Slide the new print tip into the print jet and turn it until the print tip wires are orientated to travel straight up
to the Print Jet sensor board.
LEVELING THE PRINT TIPS FOR CUBEX DUO/TRIO
!
*/
For a single print jet please see
Fastening the print tip on a
CubeX.
1
Power on the CubeX printer.
2
To clean the nozzles for levelling, put the CubeX printer into PJ-Control mode. Heat all of the print jets
EXCEPT for the new one to 230° and clean of any plastic debris with pliers. Allow the Print Jets to cool
down.