3d-printz Mini Sinbad 1200 Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Giocattolo 3d-printz Mini Sinbad 1200. 3d-printz Mini Sinbad 1200 6.

fix the canopy, which are glued into the recesses provided. The nose can be designed

either as a motor or glider nose, with the motospant being used as an intermediate piece

in both versions. The part Fus1 should be glued at the very end of assembling, after

installing the RC Components when you set your CG, as it can be used as a chamber for

trim weights. „Motorspant" can be drilled through with the needed holespacing for the

motor assembly. The motor shaft should be long enough to reach out through the motor

nose.

Deflections

Using a CG of 45mm we recommend following throws:

Aileron: +/- 8mm

Elevator: +/- 7mm

Rudder: Maximum

The right center of gravity is essential for comfortable flight behavior. This is why you

always should test it out yourself. The starting value can be chosen around 45mm behind

the leading edge. If the flight behavior is unstable, move the center of gravity further

forward. If more agile flight behaviors are desired, the center of gravity can be shifted

further back.

Please note that the center of gravity and the throws should be discovered by the pilot

himself for each build!

We wish you a lot of fun flying your Mini Sinbad!