abc 4T2 bmp 3000 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Strumenti di misura abc 4T2 bmp 3000. abc 4T2 bmp 3000 15. Broadcast multi probe

Although described in this manual, your instrument may not be equipped with all these features as

some (like the satellite receiver input) are optional.

3 Getting started

After unpacking your 4T2-bmp, please attach the power cord to the input on the right hand side of

the instrument. The connection between the tablet computer and the measurement unit is

through USB 3.0. The power signal on the USB cable is used to activate the battery inverter which

in turn activates the hardware for the ASI input, the RF input, the Spectrum Analyser, the Tracking

Generator and the Common Interface.

The USB and the IP interface is powered from the table computer directly.

Please note that once powered on, a blue light appears next to the power input connector. If the

light stays off, then the battery of the 4T2-bmp is likely to be empty.

The magnetic touch keyboard is used to protect the TFT display in transport mode.

On the right hand side, you will find connectors essential for charging and for networking:

GbE gigabit ethernet connector for networking and transport stream input and/or output

streaming

USB 3 Jumper cable between 4T2-bmp PSU and tablet computer

Charger Jumper cable between 4T2-bmp and tablet computer

Mini Display Port output for additional monitor

Main power input (12V, plus on 2.1mm center contact, reverse polarity protected)

4T2-BroadcastMultiProbe bmp3000 ManualEN.odt

Page 8