abc 4T2 bmp 3000 Manual de instruções - Página 8
Procurar online ou descarregar pdf Manual de instruções para Instrumentos de medição abc 4T2 bmp 3000. abc 4T2 bmp 3000 15 páginas. Broadcast multi probe
Imprimir páginaAlthough described in this manual, your instrument may not be equipped with all these features as
some (like the satellite receiver input) are optional.
3 Getting started
3.1 Start-up procedure
After unpacking your 4T2-bmp, please attach the power cord to the input on the right hand side of
the instrument. The connection between the tablet computer and the measurement unit is
through USB 3.0. The power signal on the USB cable is used to activate the battery inverter which
in turn activates the hardware for the ASI input, the RF input, the Spectrum Analyser, the Tracking
Generator and the Common Interface.
The USB and the IP interface is powered from the table computer directly.
Please note that once powered on, a blue light appears next to the power input connector. If the
light stays off, then the battery of the 4T2-bmp is likely to be empty.
The magnetic touch keyboard is used to protect the TFT display in transport mode.
4 Right-hand side connectors and features
On the right hand side, you will find connectors essential for charging and for networking:
GbE gigabit ethernet connector for networking and transport stream input and/or output
streaming
USB 3 Jumper cable between 4T2-bmp PSU and tablet computer
Charger Jumper cable between 4T2-bmp and tablet computer
Mini Display Port output for additional monitor
Main power input (12V, plus on 2.1mm center contact, reverse polarity protected)
4T2-BroadcastMultiProbe bmp3000 ManualEN.odt
Page 8