3DLabPrint Focke-Wulf Ta 152 C Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Giocattolo 3DLabPrint Focke-Wulf Ta 152 C. 3DLabPrint Focke-Wulf Ta 152 C 9. Fully 3d printable upgrade to short wing

Stampa la pagina

Shopping list

Printing material:
RC:
Motor:
Controller:
Battery:
Servos:
Glue:
Other:
... print your plane | www.3DLabPrint.com
0,65kg of PLA
(optionally 150g of LW-PLA)
4 channel receiver for your RC system
any motor for 3S - 6S Li-Pol with weight up to 100g
EMAX MT 3510 600KV (for 6S setup)
DYS D4215 650KV (for 6S setup)
AX-4008Q 620KV (for 6S setup, motor is discontinued
Leopard LC2830 980KV (for 3S setup)
Speed controller (ESC) YEP 40A/6S
CastleCreation Talon 25A / 6S
or similar
6S Battery LiPol 1300-1800mAh/6s
3x HXT900, or opt1, opt2,
or any similar sized servos
23x12x26 mm / 0.74x0.42x0.78 inches
2x servo extension cables 300mm / 12 inch
CA Glue - medium viscosity
Activator for CA Glue
1x 1 - 1,2 mm / 14 AWG pushrod wire or carbon rod
1x 0,8 mm pushrod wire
2x M5 fitting screws and nuts
or
2x 3mm carbon rod 125mm lenght for rubber bands
4x M3 screws and nuts for motor mount
page
- use it from your old planes)
opt3
9