3DLabPrint Focke-Wulf Ta 152 C Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Brinquedo 3DLabPrint Focke-Wulf Ta 152 C. 3DLabPrint Focke-Wulf Ta 152 C 9 páginas. Fully 3d printable upgrade to short wing

Imprimir página

Shopping list

Printing material:

RC:

Motor:

Controller:

Battery:

Servos:

Glue:

Other:

... print your plane | www.3DLabPrint.com

0,65kg of PLA

(optionally 150g of LW-PLA)

4 channel receiver for your RC system

any motor for 3S - 6S Li-Pol with weight up to 100g

EMAX MT 3510 600KV (for 6S setup)

DYS D4215 650KV (for 6S setup)

AX-4008Q 620KV (for 6S setup, motor is discontinued

Leopard LC2830 980KV (for 3S setup)

Speed controller (ESC) YEP 40A/6S

CastleCreation Talon 25A / 6S

or similar

6S Battery LiPol 1300-1800mAh/6s

3x HXT900, or opt1, opt2,

or any similar sized servos

23x12x26 mm / 0.74x0.42x0.78 inches

2x servo extension cables 300mm / 12 inch

CA Glue - medium viscosity

Activator for CA Glue

1x 1 - 1,2 mm / 14 AWG pushrod wire or carbon rod

1x 0,8 mm pushrod wire

2x M5 fitting screws and nuts

2x 3mm carbon rod 125mm lenght for rubber bands

4x M3 screws and nuts for motor mount

page

- use it from your old planes)

opt3