3Doodler Create+ Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Accessories 3Doodler Create+. 3Doodler Create+ 11.
Anche per 3Doodler Create+: Manuale d'uso (16 pagine)
4.
Plastic is leaking
from around the
nozzle
5.
Plastic won't stop
extruding
6.
I reversed the
plastic but can't
get it out
02/2022
3C.
The plastic may be wrapped around the drive gear.
Mini
Screwdriver
Remove the maintenance cover using a
mini screwdriver.
The nozzle may loosen with continued usage (or in transit).
While the pen is hot
(BLUE
or
turn the nozzle clockwise to tighten it using the mini spanner.
Stop tightening once you first feel resistance so as to avoid over-
tightening the nozzle and breaking it.
5A. Click either speed button once.
5B. If the pen keeps extruding, disconnect it from the power
supply and then plug it in and try again.
It is possible that the plastic is either too short to reverse all the way
out of your pen, or that the plastic has moved past the pen's drive
gear system.
You can check for these issues by looking through the maintenance
cover.
Plastic reversed, but is too short to take out
and is no longer in contact with the drive gear.
Plastic is beyond drive gear.
For both of these issues, you can try the
following options:
7A. While the pen is ON and extruding, insert a
new strand of plastic or use the unblocking
tool to push the remaining plastic through
the nozzle tip.
Maintenance
Cover
Use a mini screwdriver or unblocking
tool to lift and clear the plastic strand
from the drive gear through the open area
beneath the maintenance cover or from
the plastic loading port.
GREEN
LED Light is on), gently
7B. While using the reverse
SECTION 3: TROUBLESHOOTING
Mini
Spanner
feature, remove the
nozzle and use the
unblocking tool to push
the plastic out the back
of the pen.
(See
Section 3, Step
3B)
Unblocking Tool
7
EN