Baltech VP-3410 Manuale operativo - Pagina 8

Sfoglia online o scarica il pdf Manuale operativo per Strumenti di misura Baltech VP-3410. Baltech VP-3410 16. Vibration meter
Anche per Baltech VP-3410: Manuale operativo (12 pagine)

Stampa la pagina

COMMISSION OF VIBRATION METER

4.1. Operation conditions of vibration meter

• environmental temperature, °С - from 0 to +50

• relative humidity at 25 °С: to 95%

4.2. Setting-up procedures

4.2.1. and exterior check of fixture

To unpack the fixture you just need to draw it out of the

packing cartoon.

Before starting the measurements it is necessary to make

exterior check of the fixture on absence of mechanical damages

and contaminations.

To check the delivery set of the fixture according to division 3.3.

«Structure of vibration meter».

In the presence of contaminations it is necessary to make

technical service according to division 5 of the present OM.

ATTENTION

In the presence of any mechanical damages please make

sure that they do not influence on fixture reading, otherwise

send the fixture for repair.

4.2.2. Sensor installation

Vibration meter BALTECH VP-3410 uses an acceleration sensor,

which is connected to the electronic fixture with a help of low-

noise cable.

Sensor installation on the object is done with the help of magnet

clamp, shipped with the sensor.

The place of installation need to be cleaned

and put consistent lubricant for resonance

lowering. (Pic. 4-1)

Рiс. 4-1. Sensor with magnet clamp