Alton ECOMAX ELG03 Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Trimmer Alton ECOMAX ELG03. Alton ECOMAX ELG03 14. 18v cordless string trimmer
Stampa la pagina
7. STOP THE MACHINE
Release the switch button 2 in Figure 6.
8. OPERATION TIPS
WARNING! Keep clearance between the body and the machine.
WARNING! Keep clearance between the body and the machine.
Do these tips when you use the machine:
Keep the machine connected to the correctly worn harness
Keep a firm hold with the two hands on the machine while you
operate the machine
Cut tall grass from the top down
If grass winds around the trimmer head:
Remove the battery pack
Remove the grass
9. LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (Figure 7)on the guard. The
line cut off blade continuously trims the line to ensure a consistent and
efficient cut diameter. Advance line whenever you hear the engine running
faster than normal, or when trimming efficiency diminishes. This will maintain
best performance and keep line long enough to advance properly.
09
( Figure 7 )
10. CUTTING TIPS
Tilt the machine toward the area to be cut. Use the tip of the cutting line to
cut grass, as shown in figure 9
Move the machine from right to left to prevent thrown debris toward the
operator
Do not cut in the dangerous area
Do not force the trimmer head into uncut grass
Wire and picket fences cause cutting line wear and breakage. Stone and
brick walls, curbs, and wood can wear the cutting line quickly
The cutting Angle of the cutting head can be adjusted according to the
actual cutting requirements. The cutting Angle can be adjusted from 0-
22.5-45-67.5-90, as shown in figure 9
90°
67.5°
45°
22.5°
0°
Press this
button first
( Figure 8 )
11. TRIMMER EDGES
WARNING! Risk of injury! When using e cutting head upright, particular
care should be taken. Always maintain sufficient distance to the cutting
head.
NOTE: Risk of damage to the unit! Avoid contact with solid surfaces to
prevent rapid wear of the thread.
NOTE: The heel assembly only serves for easier guidance when trimming
edges. It should not be used for brush cutting and no influence on the
cutting height.
Remove the battery pack from the lawn trimmer.
Press the work head rotation button in the figure 10. Rotate to 0°.
Press the work head rotation button in the Figure 10, Rotate the Aluminum
tube 90°.
Once the adjustment is complete, as shown in Figure 11 you can edge
trimming.
Direction
Of Rotation
Danger
Area
Best Cutting Area
( Figure 9 )
10