EdgeWave iPrism 55h Manuale di avvio rapido - Pagina 2
Sfoglia online o scarica il pdf Manuale di avvio rapido per Porta d'ingresso EdgeWave iPrism 55h. EdgeWave iPrism 55h 4. Web filter appliance upgrade guide
Anche per EdgeWave iPrism 55h: Manuale di aggiornamento (12 pagine)
Stampa la paginaQuick Start Guide
V6.52X / V7.0
IMPORTANT: Please read through the Quick Start Guide prior to setup. Make sure to have your iPrism License Key file saved to your desktop, and record the
information listed in Step 1 prior to installation.
Quick Installation of iPrism
The proxy-mode configuration outlined in this guide provides an easy temporary setup for evaluating and testing iPrism using proxied
client traffic. Once you are familiar with using iPrism in Proxy-Mode, we recommend reconfiguring iPrism for Bridge-Mode deployment to
fully utilize the transparent-mode traffic management and reporting features offered by iPrism.
For more information on installation and configuration (including transitioning to Bridge-Mode), see the
on the iPrism support page at:
Step 1.
Record Setup Data for the iPrism Installation Wizard
This table applies to all iPrism h-Series Models, 15h, 25h, 35h, 55h & 105h
1.1
iPrism License Key File
The iPrism license key file was emailed to the primary contact for your account, and should be
saved to your desktop prior to running the
To request your License Key file, please visit
1.2
iPrism Model and Serial #
Record your iPrism Version and Serial Numbers for easy reference if you need to call Technical
Support.
1.3
DNS Server
The IP address of your Primary DNS (Domain Name System) Server. DNS is required for name-
resolution and email services. You can use multiple DNS Servers. If you use Windows Active
Directory specify those name servers here.
1.4
Assign an iPrism IP Address and Subnet Mask
Specify an IP address and subnet mask for the iPrism to use that corresponds with the network
in which you are placing it. This will be required for appliance discovery and later for Web-based
iPrism administration.
1.5
iPrism Default Gateway
This is the device in your network that iPrism will use to connect to the Internet. Most likely this
will be the inside interface of your Firewall.
Step 2.
Connect the iPrism and Login
Models 15h & 25h – DHCP
2.1
Connect one end of the white Ethernet Cable to the iPrism's internal interface and the other end to a switch in your LAN (where DHCP is working).
Important: Do not connect the external side of the iPrism at this point
2.2
Power up your iPrism by pressing and holding the red power button. A DHCP server automatically assigns an IP address and valid network
parameters to the iPrism.
2.3
Wait a few minutes and then go to:
2.4
When prompted, enter the 5-digit iPrism serial number and click submit.
You will be redirected to the Installation Wizard (Step 3)
http://supportdocs.edgewave.com.
Install
Wizard.
http://keyrequest.edgewave.com.
https://portal.edgewave.com/ipconfig.aspx
iPrism Web Security
iPrism Installation Guide
Example:
iprism.64641.key
You will be prompted to upload this file
during the
Install
Wizard.
iPrism Version:
iPrism Serial #:
Example:
192.168.45.30
Your Value:
Example:
192.168.45.92 and 255.255.255.0
Your Values:
Example:
192.168.45.1
Your Value:
available