EdgeWave iPrism 55h Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Gateway EdgeWave iPrism 55h. EdgeWave iPrism 55h 4 pages. Web filter appliance upgrade guide
Also for EdgeWave iPrism 55h: Upgrade Manual (12 pages)

Print Page

Quick Start Guide

V6.52X / V7.0

IMPORTANT: Please read through the Quick Start Guide prior to setup. Make sure to have your iPrism License Key file saved to your desktop, and record the

information listed in Step 1 prior to installation.

Quick Installation of iPrism

The proxy-mode configuration outlined in this guide provides an easy temporary setup for evaluating and testing iPrism using proxied

client traffic. Once you are familiar with using iPrism in Proxy-Mode, we recommend reconfiguring iPrism for Bridge-Mode deployment to

fully utilize the transparent-mode traffic management and reporting features offered by iPrism.

For more information on installation and configuration (including transitioning to Bridge-Mode), see the

on the iPrism support page at:

Step 1.

Record Setup Data for the iPrism Installation Wizard

This table applies to all iPrism h-Series Models, 15h, 25h, 35h, 55h & 105h

1.1

iPrism License Key File

The iPrism license key file was emailed to the primary contact for your account, and should be

saved to your desktop prior to running the

To request your License Key file, please visit

1.2

iPrism Model and Serial #

Record your iPrism Version and Serial Numbers for easy reference if you need to call Technical

Support.

1.3

DNS Server

The IP address of your Primary DNS (Domain Name System) Server. DNS is required for name-

resolution and email services. You can use multiple DNS Servers. If you use Windows Active

Directory specify those name servers here.

1.4

Assign an iPrism IP Address and Subnet Mask

Specify an IP address and subnet mask for the iPrism to use that corresponds with the network

in which you are placing it. This will be required for appliance discovery and later for Web-based

iPrism administration.

1.5

iPrism Default Gateway

This is the device in your network that iPrism will use to connect to the Internet. Most likely this

will be the inside interface of your Firewall.

Step 2.

Connect the iPrism and Login

Models 15h & 25h – DHCP

2.1

Connect one end of the white Ethernet Cable to the iPrism's internal interface and the other end to a switch in your LAN (where DHCP is working).

Important: Do not connect the external side of the iPrism at this point

2.2

Power up your iPrism by pressing and holding the red power button. A DHCP server automatically assigns an IP address and valid network

parameters to the iPrism.

2.3

Wait a few minutes and then go to:

2.4

When prompted, enter the 5-digit iPrism serial number and click submit.

You will be redirected to the Installation Wizard (Step 3)

http://supportdocs.edgewave.com.

Install

Wizard.

http://keyrequest.edgewave.com.

https://portal.edgewave.com/ipconfig.aspx

iPrism Web Security

iPrism Installation Guide

Example:

iprism.64641.key

You will be prompted to upload this file

during the

Install

Wizard.

iPrism Version:

iPrism Serial #:

Example:

192.168.45.30

Your Value:

Example:

192.168.45.92 and 255.255.255.0

Your Values:

Example:

192.168.45.1

Your Value:

available