AIMS Power PWRIC150012W Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Inverter AIMS Power PWRIC150012W. AIMS Power PWRIC150012W 10. Dc to ac power inverter

wattage.

Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover

all possible conditions and situations that may occur. It must be understood by the operator that

common sense and caution are factors which cannot be built into this product, but must be supplied

by operator. Guard against electric shock. Do not open the metal case; risk of electric shock.

Battery Use

•

To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20

minutes to recharge the vehicle's battery if battery voltage drops <11V.

•

To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts

= Amps. Example: 1000 watt inverter / 12 volts DC = 83.3 DC amps. In this example, you will

need 83.3 amps to power a 1000 watt load for 1 hour. If you need to power 1000 watts for 2

hours you will need 83.3 * 2 = 166.66 DC amps available. A 100 amp hour battery will give

you 100 amps / 166.66 = .6 hours so you will need two batteries if using 100 amp battery.

This is if you fully deplete your batteries. We do NOT recommend fully depleting your

batteries. This is just an example. Your power requirements may be different.

•

If you choose to use a female 12 Volt DC adapter for your inverter or to the inverter make

sure wire size is correct.

•

IF YOU CONNECT THE WIRES TO THE INCORRECT TERMINALS, YOU WILL REVERSE THE

POLARITY AND DAMAGE THE INVERTER.

•

REVERSED POLAR ITY WILL INSTANTLY VOID THE WARRANTY OF YOUR INVERTER, SO BE

CAREFUL TO CONNECT YOUR INPUT WIRES PROPEPLY.

•

If you choose to operate a battery charger to replenish your battery's voltage, be sure to

check with charger manufacture before damaging the charger.

•

CONNECTING THE INVERTER'S DC INPUT TO A BATTERY CHARGER WILL VOID THE WARRANTY,

AND MAY DAMAGE THE INVERTER.

•

Make sure that the battery voltage does not exceed 15 volts DC.

•

CONNECTING THE INVERTER TO A DC POWER SOURCE GREATER THAN 15 VDC WILL VOID

THE WARRANTY, AND MAY DAMAGE THE INVERTER.

Cables

We recommend that you refrain from using battery cables longer than 12 feet

between the DC power source and the DC input of the inverter. Longer battery cables