djm direct 01985-V2 Manuale di istruzioni originale - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni originale per Sega djm direct 01985-V2. djm direct 01985-V2 17.

Stampa la pagina

3. Fit the outer flange washer and screw in the lock nut. Hold the

drive shaft with one of the spanners on the outer flange washer

whilst simultaneously tightening the lock nut (clockwise).

Changing the blade

Warning: Make sure that the saw is disconnected from the power

supply before starting to change the saw blade. Wear safety gloves.

1. Remove the saw table insert by undoing the screw (see picture)

and lifting out the table insert.

2. Set the saw blade to its maximum height setting by turning the

hand wheel (13) clockwise.

3. Remove the old saw blade using the two spanners. Then following

the saw blade installation instructions above, making sure to adjust

the riving knife if necessary (instructions below).

11.Operation

. Make sure that the saw is completely intact and correctly

assembled before commencing work.

. Check that the saw blade is vertical (90°) and is not set higher than

is necessary to just manage to saw through the thickness of the

workpiece.

. Regularly check that all nuts and screws are tight.

ON/OFF switch (start/stop)

Plug the mains lead into a wall socket.

Switching on:

Push the green button [I] to start the motor.

Switching off:

Push the red button [0] to turn the motor off.

No-volt release switch

The saw is equipped with a no-volt release switch which prevents it

from starting automatically when the power comes back on following

a power cut. Once power has been restored the saw must be

switched on again by pressing [l].

Motor overload cut-out

If the motor is overloaded due to incorrect workpiece feed or the

saw blade being

obstructed by debris, the overload cut-out may be triggered.

If the overload safety cut-off switch is triggered:

Unplug the mains lead and let the saw cool down for at least 10

minutes.

Make sure that no contaminants hinder the rotation of the saw blade,

brush off and vacuum saw dust as and when required.

Press the overload cut-out reset button (a) pictured.

Switch the saw on by pressing [I].

Setting the saw blade height

Turn the hand wheel (13) to set the desired height. Never set the

blade higher than is necessary to saw through the workpiece.

Adjusting the Parallel

Pull the clamping lever (b) upwards.

Move the cross stop (16) into the required position.

The set position can be read from the scale .

Press the clamping lever (b) down.