djm direct 01985-V2 Manuale di istruzioni originale - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni originale per Sega djm direct 01985-V2. djm direct 01985-V2 17.

Stampa la pagina

Mitre gauge

Slide the mitre gauge into one of the slots on the table.

Undo the locking knob (c) and set the desired angle. Tighten the

locking knob again.

If necessary, undo the two wing nuts (d) and move the rip fence to

the side so that it does not catch on the blade, then tighten the wing

nuts again.

Setting the blade tilt

Note: Check all the angles before starting to saw.

Undo the locking knob (14) and set the desired angle.

Tighten the locking knob again.

Rip cutting

Note:

Rehearse every step of the cutting task without turning the saw on

if you are unsure how to hold the workpiece and work safely.

Make a test cut and measure before starting to rip cut on the actual

workpiece.

Always let the saw come up to full speed before starting to cut.

Be extra careful at the beginning of every cut.

When rip-cutting thick workpieces where the saw blade is set to its

maximum height: check that the riving knife is set to its maximum

height setting otherwise there is a risk of the workpiece fastening on

the blade guard. Refer to the Adjusting the riving knife section.

Hold one side of the material against the rip fence and the flat face

against the surface of the table.

Do not stand directly behind the workpiece when rip cutting. The

workpiece can be thrown back towards the operator.

Place your hands on the workpiece and press it against the table

and the rip fence. Feed the workpiece into the blade in a controlled

and smooth motion.

Warning: Always use a push-stick if any of your hands comes closer

than 125.mm to the saw blade during the. cutting process. Never use

a damaged push-stick, replace a damaged stick before resuming

work.

12. Maintenance and Cleaning

Before any work on the machine itself, pull the mains plug.

If the machine should fail despite the care taken in manufacturing

and testing procedures, repair should be carried out by an approve

service centre.

– Store the tool, instruction manual and accessories in a secure place.

In this way you will always have all the information and parts on

hand.

Cleaning

– For safe and proper working, always keep the power too land its

ventilation slots clean.

– Remove dust and chips after each working procedure by blowing

out with compressed air or with a brush.