djm direct 01985-V2 Оригінальна інструкція з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Пила. djm direct 01985-V2. djm direct 01985-V2 17 сторінок.
Друкувати сторінкуMitre gauge
Slide the mitre gauge into one of the slots on the table.
Undo the locking knob (c) and set the desired angle. Tighten the
locking knob again.
If necessary, undo the two wing nuts (d) and move the rip fence to
the side so that it does not catch on the blade, then tighten the wing
nuts again.
Setting the blade tilt
Note: Check all the angles before starting to saw.
Undo the locking knob (14) and set the desired angle.
Tighten the locking knob again.
Rip cutting
Note:
Rehearse every step of the cutting task without turning the saw on
if you are unsure how to hold the workpiece and work safely.
Make a test cut and measure before starting to rip cut on the actual
workpiece.
Always let the saw come up to full speed before starting to cut.
Be extra careful at the beginning of every cut.
When rip-cutting thick workpieces where the saw blade is set to its
maximum height: check that the riving knife is set to its maximum
height setting otherwise there is a risk of the workpiece fastening on
the blade guard. Refer to the Adjusting the riving knife section.
Hold one side of the material against the rip fence and the flat face
against the surface of the table.
Do not stand directly behind the workpiece when rip cutting. The
workpiece can be thrown back towards the operator.
Place your hands on the workpiece and press it against the table
and the rip fence. Feed the workpiece into the blade in a controlled
and smooth motion.
Warning: Always use a push-stick if any of your hands comes closer
than 125.mm to the saw blade during the. cutting process. Never use
a damaged push-stick, replace a damaged stick before resuming
work.
12. Maintenance and Cleaning
Before any work on the machine itself, pull the mains plug.
If the machine should fail despite the care taken in manufacturing
and testing procedures, repair should be carried out by an approve
service centre.
– Store the tool, instruction manual and accessories in a secure place.
In this way you will always have all the information and parts on
hand.
Cleaning
– For safe and proper working, always keep the power too land its
ventilation slots clean.
– Remove dust and chips after each working procedure by blowing
out with compressed air or with a brush.
10