Custom Crimp D205WB Series Manuale dell'operatore - Pagina 7
Sfoglia online o scarica il pdf Manuale dell'operatore per Utensile a crimpare Custom Crimp D205WB Series. Custom Crimp D205WB Series 17. Service hose crimper
Stampa la pagina
D205WB / D206WB
Grease Point # 1
Place a thin layer of CrimpX grease (supplied with crimper)
or a high pressure molybdenum high pressure grease
on the surface of the bottom fl ange.
(as shown in photo # 1).
Grease Point # 2
Before sliding the large pressure plate over the correct dies,
place a thin layer of CrimpX grease (supplied with crimper)
or a high pressure
molybdenum high pressure grease on the entire area that
dies come in contact with (as shown in photo # 2).
If Dies are sticking in the surface of the bottom fl ange:
Continue to lubricate / grease as explained above in addition
to lubricating each die fi nger individually.
(as shown in photo # 3).
Note:
The die fi ngers must be lubricated at the positions
that come in contact with the pressure plate and the
bottom fl ange.
Note:
Lubrication is not required before each crimp.
Typical lubrication is after 100 crimps.
Service Hose Crimper
EN98-032 LUBRICATION PROCEDURE
Photo # 1
Photo # 2
Photo # 3
7