Custom Crimp D205WB Series 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Custom Crimp D205WB Series에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Crimp D205WB Series 17 페이지. Service hose crimper

D205WB / D206WB

Grease Point # 1

Place a thin layer of CrimpX grease (supplied with crimper)

or a high pressure molybdenum high pressure grease

on the surface of the bottom ﬂ ange.

(as shown in photo # 1).

Grease Point # 2

Before sliding the large pressure plate over the correct dies,

place a thin layer of CrimpX grease (supplied with crimper)

or a high pressure

molybdenum high pressure grease on the entire area that

dies come in contact with (as shown in photo # 2).

If Dies are sticking in the surface of the bottom ﬂ ange:

Continue to lubricate / grease as explained above in addition

to lubricating each die ﬁ nger individually.

(as shown in photo # 3).

Note:

The die ﬁ ngers must be lubricated at the positions

that come in contact with the pressure plate and the

bottom ﬂ ange.

Note:

Lubrication is not required before each crimp.

Typical lubrication is after 100 crimps.

Service Hose Crimper

EN98-032 LUBRICATION PROCEDURE

Photo # 1

Photo # 2

Photo # 3