Artison Sketch LCR DualMono MK 2 Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Altoparlanti Artison Sketch LCR DualMono MK 2. Artison Sketch LCR DualMono MK 2 16.
Anche per Artison Sketch LCR DualMono MK 2: Manuale di riferimento rapido (4 pagine), Manuale di riferimento rapido (4 pagine), Manuale di installazione (4 pagine)

WIRING THE LCRS

3 CHANNEL METHOD (Left, DualMono Center and Right)

1. Operate the terminals by firmly pressing on them. An opening will be exposed in the side of

the terminal. Slip about 9 mm (3/8") of bare speaker wire into this opening hole and release

the terminal. The spring loaded terminal will now securely hold the wire in place. 16 gauge is

the minimum requirement. Depending upon total wire length a larger gauge may be used. 12

gauge is the maximum that will fit into the gold push terminals.

2. Left and Right Channels

2.1. Connect two conductor speaker wire between each channel and the receiver or amplifier.

Mind the polarity of the wiring is consistent. (+ to +, - to -)

3. DualMono Center Channels

3.1.

Using the supplied 2 meter speaker wire, connect both center channels together in

parallel. This is done by connecting Red to Red and Black to Black, (+ to +, - to -).

3.2.

Connect two conductor speaker wire between one of the DualMono Center Channels

and the receiver or amplifier. The wire from the amplifier and the wire from the opposite

center channel should be twisted together and placed in the terminals. Mind the polarity

of the wiring is consistent. (+ to +, - to -)

4. Refer to FIGURE 3.

5. NOTE: This can be achieved by using 2 runs of 4 conductor speaker wire. One run per

side of the FPTV. Separate the 4 conductors into 2 pairs. Connect one pair to each

channel. The parallel connection of the DualMono Center Channels can be made at the

amplifier.

2 CHANNEL METHOD (Left/Right Stereo)

Using a single conductor of speaker wire, connect the negative terminal of the Left Channel to

the positive terminal of the DualMono Center Channel in the same cabinet. This puts the two

channels in series.

Similarly, connect a single conductor from the negative terminal of the Right Channel to the

positive terminal of the DualMono Center Channel in the same cabinet.

Using two conductor speaker wire, connect the Left and Right channel outputs of the receiver

or amplifier to the pair of unused + and - terminals on each corresponding side.

Refer to FIGURE 4.