Artison Sketch LCR DualMono MK 2 Kurulum Kılavuzu - Sayfa 6
Konuşmacılar Artison Sketch LCR DualMono MK 2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Artison Sketch LCR DualMono MK 2 16 sayfaları.
Ayrıca Artison Sketch LCR DualMono MK 2 için: Hızlı Referans Kılavuzu (4 sayfalar), Hızlı Referans Kılavuzu (4 sayfalar), Kurulum Kılavuzu (4 sayfalar)
Sayfayı Yazdır
WIRING THE LCRS
3 CHANNEL METHOD (Left, DualMono Center and Right)
1. Operate the terminals by firmly pressing on them. An opening will be exposed in the side of
the terminal. Slip about 9 mm (3/8") of bare speaker wire into this opening hole and release
the terminal. The spring loaded terminal will now securely hold the wire in place. 16 gauge is
the minimum requirement. Depending upon total wire length a larger gauge may be used. 12
gauge is the maximum that will fit into the gold push terminals.
2. Left and Right Channels
2.1. Connect two conductor speaker wire between each channel and the receiver or amplifier.
Mind the polarity of the wiring is consistent. (+ to +, - to -)
3. DualMono Center Channels
3.1.
Using the supplied 2 meter speaker wire, connect both center channels together in
parallel. This is done by connecting Red to Red and Black to Black, (+ to +, - to -).
3.2.
Connect two conductor speaker wire between one of the DualMono Center Channels
and the receiver or amplifier. The wire from the amplifier and the wire from the opposite
center channel should be twisted together and placed in the terminals. Mind the polarity
of the wiring is consistent. (+ to +, - to -)
4. Refer to FIGURE 3.
5. NOTE: This can be achieved by using 2 runs of 4 conductor speaker wire. One run per
side of the FPTV. Separate the 4 conductors into 2 pairs. Connect one pair to each
channel. The parallel connection of the DualMono Center Channels can be made at the
amplifier.
2 CHANNEL METHOD (Left/Right Stereo)
1.
Using a single conductor of speaker wire, connect the negative terminal of the Left Channel to
the positive terminal of the DualMono Center Channel in the same cabinet. This puts the two
channels in series.
2.
Similarly, connect a single conductor from the negative terminal of the Right Channel to the
positive terminal of the DualMono Center Channel in the same cabinet.
3.
Using two conductor speaker wire, connect the Left and Right channel outputs of the receiver
or amplifier to the pair of unused + and - terminals on each corresponding side.
4.
Refer to FIGURE 4.
6