Artison Sound Surface 40 Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Altoparlanti Artison Sound Surface 40. Artison Sound Surface 40 11. Invisible speaker

Stampa la pagina

6) Connect Wires

Before installing the speaker into wall or ceiling, the

speaker wire connections must be made. Read the

IMPORTANT items before making connections. Follow

steps below to make these connections:

IMPORTANT: Read items below before making speak-

er connections:

–

Observe polarity when attaching speaker wires.

Connect the positive speaker wire to the side of

connector with the red stripe. Note: The connector

must be removed from speaker to see the stripe.

–

Twist the bare portion of each wire before installing

to ensure no exposed copper strands are sticking

out that could short to other wires.

–

To reduce the chance of wires shorting, no more

than

inch of bare wire should protrude from the

rear of each connection.

–

Do not solder the cable to the connector.

–

Do not tin the strands of the wire with solder.

–

Screw the connector to its mating side on the

speaker. This ensures the connector doesn't unplug

when mounting speaker into wall.

–

Secure the speaker wire to the relief strap. See

Figure 9.

Unplug the phoenix connector from the speaker.

3 /

2. Strip

inch of the jacketing from speaker wires

coming out of the wall.

3. Slide wires into connector as shown in Figure 8.

4. Twist each screw on the top of the connector

clockwise (CW) until the silver crimps tighten around

each wire. Tug on wire a bit to verify they are secure.

See Figure 8.

5. Route the speaker wires through the strain relief

strap and tighten strap to secure wires to speaker.

6. Plug the connector back into the speaker. Secure

the connector to the speaker by tightening the

two screws on the front of the connector. Verify

connector is secured to the speaker by pulling on it a

bit to ensure it won't pull out.

With the speaker wires connected, turn the audio

source on and verify the speakers work.

7) Mount Speaker into Wall

With the wire secured to the strain relief strap,

insert all loose wiring into the wall cavity.

2. Grasp the installation handle mounted on the

speaker and insert the speaker into wall. Slide

speaker up into wall until bottom of speaker can be

inserted into cut out hole. See Figure 10.

Surface 40/80 Speakers | 009-1656-01 | 180731

Installation

Figure 8.

Relief Strap

Figure 9.

Figure 10.

6 of 11

⅜

(9.5 mm)

Slide Speaker

Up into Wall

45 Perseverance Way, Hyannis, MA 02601

Savant.com

| 508.683.2500