Artison RCC600-SM Manuale di installazione - Pagina 7
Sfoglia online o scarica il pdf Manuale di installazione per Subwoofer Artison RCC600-SM. Artison RCC600-SM 19. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Anche per Artison RCC600-SM: Manuale di installazione (13 pagine)
RCC 600 SUBWOOFER AMPLIFIER (RCC600-SA)
The RCC 600 Subwoofer Amplifier can be installed into either cabinetry, on an equipment shelf, or
it can be rack-mounted into a standard 19" Eauioment Rack. In anv installation be sure to
-
-- - - -
-
-
-
-,
I
.,
provide adequate ventilation around the amplifier.
The RCC600-SA has two simple and conveniently placed mode settings. The Music or Movie
user controls are located on the front panel for selection based on the source material. The Mode
settings, Volume and Power Controls of the RCC600-SA can be accessed via IR codes. The
remote included with your unit can be downloaded into a learning remote or HEX Codes are
available on the Artison Web site. The Front Panel of the RCC600-SA has an IR Receiver and
there is a second hard wired feed thru jack that can be connected to an integrated control system
on the rear panel. Each control is described in detail below.
RACKMOUNT INSTALLATION OF THE RCC600-SA
1. Remove the amplifier's four feet from the bottom of the chassis.
2. Attach the included rack-mount ears to the front sides of the RCC600-SA.
3. Mount into the 19" equipment rack, the amplifier will occupy 1.5 RU. Using the supplied
.
~
RU Blank Spacer either above or below the amplifier will occupy 2 RU.
4. If installing two RCC600-SA then the rack-mount ears can be flipped to accommodate the two
amplifiers in 3 RU.
RCC600-SA REMOTE CONTROL
The remote control has the following functions:
1. ON/OFF - This will toggle between Standby Mode (Amber Halo) and ON (Blue Halo).
2. MUSIC - This selects the MUSIC Ea. When active it will have a Red Halo added to the Blue
Halo.
3. MOVIE - This selects the MUSIC Ea. When active it will have a Red Halo added to the Blue
Halo.
4. GAIN - This will raise and lower the volume of the amplifier. A remote or the Gain Knob on the
front panel can both be used to raise or lower the volume.
NOTE: The gain control is
configured so that the "last used" device setting will be remembered by the amplifier.
7