Artison RCC600-SM Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Сабвуфер Artison RCC600-SM. Artison RCC600-SM 19 сторінок. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Також для Artison RCC600-SM: Посібник з монтажу (13 сторінок)

Друкувати сторінку

RCC 600 SUBWOOFER AMPLIFIER (RCC600-SA)

The RCC 600 Subwoofer Amplifier can be installed into either cabinetry, on an equipment shelf, or

it can be rack-mounted into a standard 19" Eauioment Rack. In anv installation be sure to

-- - - -

provide adequate ventilation around the amplifier.

The RCC600-SA has two simple and conveniently placed mode settings. The Music or Movie

user controls are located on the front panel for selection based on the source material. The Mode

settings, Volume and Power Controls of the RCC600-SA can be accessed via IR codes. The

remote included with your unit can be downloaded into a learning remote or HEX Codes are

available on the Artison Web site. The Front Panel of the RCC600-SA has an IR Receiver and

there is a second hard wired feed thru jack that can be connected to an integrated control system

on the rear panel. Each control is described in detail below.

RACKMOUNT INSTALLATION OF THE RCC600-SA

1. Remove the amplifier's four feet from the bottom of the chassis.

2. Attach the included rack-mount ears to the front sides of the RCC600-SA.

3. Mount into the 19" equipment rack, the amplifier will occupy 1.5 RU. Using the supplied

RU Blank Spacer either above or below the amplifier will occupy 2 RU.

4. If installing two RCC600-SA then the rack-mount ears can be flipped to accommodate the two

amplifiers in 3 RU.

RCC600-SA REMOTE CONTROL

The remote control has the following functions:

1. ON/OFF - This will toggle between Standby Mode (Amber Halo) and ON (Blue Halo).

2. MUSIC - This selects the MUSIC Ea. When active it will have a Red Halo added to the Blue

Halo.

3. MOVIE - This selects the MUSIC Ea. When active it will have a Red Halo added to the Blue

Halo.

4. GAIN - This will raise and lower the volume of the amplifier. A remote or the Gain Knob on the

front panel can both be used to raise or lower the volume.

NOTE: The gain control is

configured so that the "last used" device setting will be remembered by the amplifier.