aluexbeams ALUEX10+ Istruzioni per l'uso - Pagina 4

Sfoglia online o scarica il pdf Istruzioni per l'uso per Sistemi di sollevamento aluexbeams ALUEX10+. aluexbeams ALUEX10+ 4.

The lift spreader must not be used under the hazardous circumstances, e.g. in strong winds (the load

may sway). The lift spreader must not be used to lift people. When lifting loads, it is necessary to check

first that there is nobody beneath or in the vicinity of the load.

be used for lifting for which it designed.

centrally beneath the lift spreader (see Figure 11).

Figure

10:The points where the lifting

straps leave the load must form a rectangle

Users of the lift spreader must be aware of

needed to use it, but the user should be aware of the lifting process before using it. The user must read the

instructions for use before using the lift spreader. The user must check the condition of the

prior to use.

Handling and storage

The lift spreader must be stored indoors and protected against moisture and weather. The lift spreader must

be secured while in storage so that there are no residual tensions in the lift spreader's attachment points.

The device must be stored in the maximum folded position. The lift spreader must be dried and cleaned

prior to storage.

Maintenance and inspection

The condition of the lift spreader must always be checked prior to use. The attachment points of the lift

spreader must be replaced if they are damaged or clearly worn. The lift spreader must be inspected once a

year. All brackets and the general condition of the product must be reviewed in this case. The lift spreader

must be opened for inspection, and all guide pins must be checked individually. The product must be

taken out of service if it is damaged. The guide pins must be replaced if they are damaged. Only

original spare parts are approved

Maximum lateral clearance is 15mm on the extension

The annual inspection must be noted in the inspection log.

alue \ beams

The centre of gravity of the load must be located

Figure 11:

located centrally beneath the lift spreader

the purposes for which it can be used. No special training is

The lift spreader may only

The centre of gravity of the load must be

Page 4/4

Instructions for use

original

lift spreader

Manufacturer

Oy Aluexbeams Ab

Jakobstad Finland

+358400471058