Alula RE209 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Sensori di sicurezza Alula RE209. Alula RE209 2. Glassbreak honeywell compatible

Stampa la pagina

Resolution Compatibles

The RE209 Glassbreak

breaking glass and sends alarm signals to the security panel.

Features

• 360 degree omni-directional coverage

• Optional external contact

• Low battery indication

• 5-year warranty

Enroll

by placing the panel into wireless enrollment mode, removing the

battery tab, and pressing the enrollment button.

Sending an Enrollment Signal

• Press the enrollment button to enroll

• Select Loop 1 for Glassbreak

Install

by mounting the sensor at least 3 feet (~1 m), but no more than

25 feet (~7.5m), from a window using the mounting screw locations

or VHB tape. Ensure that the sensor has visual line-of-sight to all

windows being protected.

Glassbreak Testers

and installation (use any glassbreak tester).

• Putting Sensor in Test Mode:

1. Put tester on tempered setting.

2. Hold tester next to the microphone and activate tester.

3. The red LED will light for 4 seconds.

4. Sensor sends alarm to control panel.

• Red LED will blink one time per second for one minute (Test Mode.)

• Every time the sensor hears the tester in Test Mode, the red LED will

light for four seconds and sensor sends alarm.

• In Test Mode:

1. Test sensor distance – holding tester near surface of the

window protected, activate tester with speaker pointed

towards sensor.

2. If the red LED does not light for 4 seconds, relocate sensor

and retest.

3. When location is verified and a good test is confirmed, the

red LED will stop blinking 1 minute after last tester sound

it hears.

NOTE: The pattern recognition technology of this sensor

ignores most false alarm sounds, including glassbreak

testers (except in test mode).

Enroll an External Contact

then selecting Loop 3 for External Contact.

External Contact

• Connect the external contact to terminal B and

the middle terminal

• Use only a normally-closed contact

• Do not use end-of-line resistors

Use the panel installation guide to verify proper system setup.

RE209 Glassbreak

Honeywell

is a security sensor that detects the sound of

should be used to verify operation after enrollment

by pushing the Enrollment button and

Compatible

Enroll Button

External Contact

Terminal Block

LED