Alula RE209 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Датчики безпеки Alula RE209. Alula RE209 2 сторінки. Glassbreak honeywell compatible

Друкувати сторінку

Resolution Compatibles

The RE209 Glassbreak

breaking glass and sends alarm signals to the security panel.

Features

• 360 degree omni-directional coverage

• Optional external contact

• Low battery indication

• 5-year warranty

Enroll

by placing the panel into wireless enrollment mode, removing the

battery tab, and pressing the enrollment button.

Sending an Enrollment Signal

• Press the enrollment button to enroll

• Select Loop 1 for Glassbreak

Install

by mounting the sensor at least 3 feet (~1 m), but no more than

25 feet (~7.5m), from a window using the mounting screw locations

or VHB tape. Ensure that the sensor has visual line-of-sight to all

windows being protected.

Glassbreak Testers

and installation (use any glassbreak tester).

• Putting Sensor in Test Mode:

1. Put tester on tempered setting.

2. Hold tester next to the microphone and activate tester.

3. The red LED will light for 4 seconds.

4. Sensor sends alarm to control panel.

• Red LED will blink one time per second for one minute (Test Mode.)

• Every time the sensor hears the tester in Test Mode, the red LED will

light for four seconds and sensor sends alarm.

• In Test Mode:

1. Test sensor distance – holding tester near surface of the

window protected, activate tester with speaker pointed

towards sensor.

2. If the red LED does not light for 4 seconds, relocate sensor

and retest.

3. When location is verified and a good test is confirmed, the

red LED will stop blinking 1 minute after last tester sound

it hears.

NOTE: The pattern recognition technology of this sensor

ignores most false alarm sounds, including glassbreak

testers (except in test mode).

Enroll an External Contact

then selecting Loop 3 for External Contact.

External Contact

• Connect the external contact to terminal B and

the middle terminal

• Use only a normally-closed contact

• Do not use end-of-line resistors

Use the panel installation guide to verify proper system setup.

RE209 Glassbreak

Honeywell

is a security sensor that detects the sound of

should be used to verify operation after enrollment

by pushing the Enrollment button and

Compatible

Enroll Button

External Contact

Terminal Block

LED