Cutter Industries Automatic Cutter III Manuale di configurazione

Sfoglia online o scarica il pdf Manuale di configurazione per Cutter Cutter Industries Automatic Cutter III. Cutter Industries Automatic Cutter III 2.

Cutter Industries Automatic Cutter III Manuale di configurazione
Troubleshooting
Always disconnect from power source when troubleshooting!
REASON
Material not cutting off cleanly/completely
Dull or damaged cut-blade
Loose shoulder-bolt holding top of
cut-blade
Foreign material in solenoid-arm is
shortening blade travel
Material not feeding properly
Flattened width of material greater
than feed system or incoming material
obstructed
Drive-roller knurling filled with foreign
material
Cut-blade not returning to neutral
position
Motor not turning
Tension arm not holding material
against drive-roller
Tension arm roller not turning freely.
End-of-spool material left between
drive-roller & exit
Inlet feed-guide not in place with small
material
Copyright © 2016 Cutter Industries, Inc. All rights reserved. Operational software manufactured by Cutter
Industries, Inc. is protected by the copyright laws of the United States. ©1998, 1999, 2000, 2005, 2008, 2015.
SOLUTION
Sharpen or replace cut-blade. (See
Change Cut-Blade in Setup Guide.)
Adjust shoulder-bolt. (See Cut-Blade
Adjustment in Setup Guide.)
Remove exit-side cover (See Internal
Access in Setup Guide). Clear material
from solenoid-arm.
Remove covers (See Internal Access in
Setup Guide). If possible, remove the
obstruction.
Clean knurls with steel brush, through
inlet hole.
Adjust cut-blade. (See Cut-Blade
Adjustment in Setup Guide.)
Remove covers (See Internal Access in
Setup Guide.) and clear fan obstruction.
Replace/strengthen tension arm spring.
Requires factory adjustment/
replacement
Remove material through Exit side, with
needle-nose pliers.
Adjust feed-guide as necessary.
Automatic Cutter II & III
Set-up Guide
Automatic Cutter II
Wire 12 to 40 AWG
Tubing to 3/8" OD (Heat Shrink to 1/4" OD)
Automatic Cutter III
Wire 10 to 18 AWG
Tubing to 1/2" OD (Heat Shrink to 5/16" OD)
Cutter Industries Inc.
417-533-1019
AutomaticWireCutter.com