Doberman Security SE-0212 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Accessori per computer Doberman Security SE-0212. Doberman Security SE-0212 4. Pc data lock

Stampa la pagina

PACKAGE INCLUDES:

Transmitter...1PC

Receiver ...1PC

CR 2032 battery... 1PC

Soft Driver ... 1PC

OPERATIONS:

After installing the software, insert the receiver into the USB port of your PC or laptop computer. Take the transmitter

with you.

Take out the isolation tape, and press the round button of the transmitter to turn it on.

The green LED on the transmitter will flash. The transmitter is now on and the PC Data Lock is activated. Your PC data

is now being protected.

When you walk away from your computer, take the transmitter with you. Then computer automatically enters Lock

Mode when you are away from the computer by approximately 7 feet.

The computer automatically resumes normal operation when you are back to within the 7 foot range.

Once the computer enters the Lock Mode, a password is required to unlock the computer, if the transmitter and receiver

pair is not available to unlock the computer. For example: The receiver is not plugged in the USB, or you forget to bring

the transmitter.

HARDWARE INSTALLATION:

Insert the PC Data Lock receiver into the USB

port. The computer will determine if the

hardware is properly installed

If computer fails to detect the receiver

device after the hardware installation, the

side window will display on the screen.

Click the Exit Setup button and repeat the

step above again.

If the sideward window is displayed

on the screen, click the Confirm

button to cancel the installation.

An installation procedure will be automatically be activated once the

computer successfully detects the PC Data Lock hardware.

Next, double check to see if:

The USB port is fully functional.

The PC Data Lock receiver is properly inserted into the USB port.

For best performance, it is recommended to connect the PC Data Lock into the original USB port instead of a hub or

extension cable

HARDWARE REMOVAL:

Unplug the PC Data Lock receiver from the USB port.

SOFTWARE INSTALLATION:

Automatic Installation:

Place the driver software CD, which comes with the PC Data Lock, into the CD-ROM drive of the computer.. It will

automatically read and execute the installation program. The computer screen will look similar to the one below. To

install the software, simply follow the on-screen instructions. Click the Confirm button to start the installation (or the

View button to list other options.)

Figure

SE-0212 PC Data Lock

Figure2

When the software is installing, the computer

screen will look similar to the one on the right