Doberman Security SE-0212 Посібник із швидкого старту
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Комп'ютерні аксесуари Doberman Security SE-0212. Doberman Security SE-0212 4 сторінки. Pc data lock
Друкувати сторінкуPACKAGE INCLUDES:
Transmitter...1PC
Receiver ...1PC
CR 2032 battery... 1PC
Soft Driver ... 1PC
OPERATIONS:
After installing the software, insert the receiver into the USB port of your PC or laptop computer. Take the transmitter
with you.
Take out the isolation tape, and press the round button of the transmitter to turn it on.
The green LED on the transmitter will flash. The transmitter is now on and the PC Data Lock is activated. Your PC data
is now being protected.
When you walk away from your computer, take the transmitter with you. Then computer automatically enters Lock
Mode when you are away from the computer by approximately 7 feet.
The computer automatically resumes normal operation when you are back to within the 7 foot range.
Once the computer enters the Lock Mode, a password is required to unlock the computer, if the transmitter and receiver
pair is not available to unlock the computer. For example: The receiver is not plugged in the USB, or you forget to bring
the transmitter.
HARDWARE INSTALLATION:
Insert the PC Data Lock receiver into the USB
port. The computer will determine if the
hardware is properly installed
If computer fails to detect the receiver
device after the hardware installation, the
side window will display on the screen.
Click the Exit Setup button and repeat the
step above again.
If the sideward window is displayed
on the screen, click the Confirm
button to cancel the installation.
An installation procedure will be automatically be activated once the
computer successfully detects the PC Data Lock hardware.
Next, double check to see if:
The USB port is fully functional.
The PC Data Lock receiver is properly inserted into the USB port.
For best performance, it is recommended to connect the PC Data Lock into the original USB port instead of a hub or
extension cable
HARDWARE REMOVAL:
Unplug the PC Data Lock receiver from the USB port.
SOFTWARE INSTALLATION:
Automatic Installation:
Place the driver software CD, which comes with the PC Data Lock, into the CD-ROM drive of the computer.. It will
automatically read and execute the installation program. The computer screen will look similar to the one below. To
install the software, simply follow the on-screen instructions. Click the Confirm button to start the installation (or the
View button to list other options.)
Figure
1
SE-0212 PC Data Lock
Figure2
When the software is installing, the computer
screen will look similar to the one on the right
1