DockStar Smart Thruster Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Attrezzatura per la nautica DockStar Smart Thruster. DockStar Smart Thruster 16. Stern
Anche per DockStar Smart Thruster: Manuale operativo (15 pagine)

Stampa la pagina

The stanchion is 32" long. The T-track is 22" long, and

the stainless tube for the track is 25" long.

To mount this T-track assembly configuration it is only

necessary to drill the four holes for the stanchion base

and to secure it with the four screws, fender washers,

and nylock nuts. It is a good practice to seal the

bottom of the stanchion with a good marine sealant.

The stanchion base must be placed close enough to

the edge of the swim step to allow clearance for the

thruster to slide down the T-track. Care should be

taken to align the rotation of the stanchion base such

that the face of the T-track is parallel to the aft edge of

the swim step. This will ensure that the thruster

motors run parallel to the aft edge of the swim step.

For some swim steps it may be necessary to add a

stanchion brace to this stanchion to minimize the

flexing caused by the torque exerted by the thruster

onto the base and thus onto the swim step

immediately around the base.

It may also be necessary to use a backing plate on the

bottom of the swim step to spread the load out. It all

depends on the nature of the swim step.

Even with a solid swim step, there will be noticeable

flexing of the stanchion tube. The use of a stanchion

brace will virtually eliminate this.

The following images show the stanchion mount configuration installed.

Page 5/ 16