DOD FX7 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione DOD FX7. DOD FX7 18. Dod guitar effects processor/preamp owner's manual fx7

Stampa la pagina

SECTION 2 - PROGRAMMING THE FX7

Navigating The FX7

DATA

Using The Footswitches

signal processing

The FX7 is designed to be both easy to program and flexible. The

structure of an FX7 Program is logical, and it doesn't require a lot of

time to master.

To select Programs in the FX7:

1) After you power up, use the Data wheel to scroll through the

Programs. As you scroll, the effect group and footswitch LEDs

turn on and off. These LEDs indicate which effects are used in

each Program, and which Program in the Bank is selected.

There are 11 effect groupings printed on the front panel of the FX7.

Seven are digital effect groups (delay, reverb, etc.) , and four cover the

preamp section (compression, distortion, gate, EQ). Each group has

its own LED that indicates the status of each group.

If the Status LED is lit continuously, an effect in the indicated group is

active. If the LED is not lit, no effects in the group are active. If the

LED is flashing, edit mode is active, and effects in the group can be

selected using the Data wheel.

Directly below each vertical group are the Effect Selector buttons.

These buttons allow you to select and/or bypass effects in the FX7.

The following things happen when you use the Effect Selector buttons:

• When you select a bypassed effect, its group LED begins flashing

and the display shows two dashes, indicating that the effect is

selected but bypassed. (Pressing the Select button again acti-

vates the effect.)

• When you select an active effect, its group LED begins flashing

and the display shows the number of the currently selected

effect. (Pressing the button again bypasses the effect.)

When lit, the User LED below the display indicates that the current

Program is a User Program. When the LED is not lit, the current

Program is a permanent Factory Program.

The FX7's pedalboard consists of four footswitches: the far right

footswitch is the Bank selector, and the remaining three are Program

selectors.

A Bank is a group of three Programs. There are 10 User Banks in the

FX7, each with 3 Programs for a total of 30 User Programs. There are

also 30 Factory Programs that can be selected using the Data wheel

only. User Programs in any of the Banks can be recalled in one of two

ways:

• by pressing the Bank select footswitch followed by footswitch 1,

2, or 3.

• by turning the Data wheel in Program mode.

To select Programs using the footswitches:

FX7 owner's manual