Dogtrace d-control easy Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per Prodotto per la cura degli animali domestici Dogtrace d-control easy. Dogtrace d-control easy 19. Electronic training collar
Battery installation and replacement
INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)
Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver. Install
the 3V lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB with "+" symbol
in the battery compartment (see the photo).
A beep indicating correct installation of battery will sound.
If you do not hear the beep after installation of the battery, remove it immediately. Check the
polarity and try to install it again.
Before putting the plate cover to its place make sure that the rubber seal is correctly seated in its
slot. Tighten adequately the 4 screws on the cover plate of the receiver.
Checking the battery state
Look at the indicator on the front panel of the receiver (collar) to
check the state of battery:
The battery is fully charged: When on-state, the LED flashes
slowly in green.
The battery is flat: When on-state, the LED flashes red. Prepare
a spare 3V lithium battery CR2 and follow the section
describing how to install the battery in the receiver.
Make sure that the receiver works correctly.
6
Battery polarity indication