Dogtrace d-control easy 사용자 설명서 - 페이지 6

{카테고리_이름} Dogtrace d-control easy에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtrace d-control easy 19 페이지. Electronic training collar

Battery installation and replacement

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)

Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver. Install



the 3V lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB with "+" symbol

in the battery compartment (see the photo).

A beep indicating correct installation of battery will sound.



If you do not hear the beep after installation of the battery, remove it immediately. Check the



polarity and try to install it again.

Before putting the plate cover to its place make sure that the rubber seal is correctly seated in its



slot. Tighten adequately the 4 screws on the cover plate of the receiver.

Checking the battery state

Look at the indicator on the front panel of the receiver (collar) to

check the state of battery:

The battery is fully charged: When on-state, the LED flashes



slowly in green.

The battery is flat: When on-state, the LED flashes red. Prepare



a spare 3V lithium battery CR2 and follow the section

describing how to install the battery in the receiver.

Make sure that the receiver works correctly.

Battery polarity indication