d&b audiotechnik Z Series Istruzioni per il montaggio - Pagina 5

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Supporto per TV d&b audiotechnik Z Series. d&b audiotechnik Z Series 11. Al flying adapter
Anche per d&b audiotechnik Z Series: Istruzioni per il montaggio (14 pagine), Istruzioni per il montaggio (8 pagine), Istruzioni per il montaggio (7 pagine), Manuale d'attrezzatura (18 pagine), Istruzioni per il montaggio (12 pagine), Istruzioni per il montaggio (10 pagine)

[1a]

[1b]

Rota clamp assembly with flying adapter

Fixing bolt secured

Function of the securing pin (ring cotter)

d&b Z5147 Mounting instructions 2.3 en

1.3 Intended use

The Rota clamp must only be used to suspend d&b loudspeaker

cabinets from a single suspension point in connection with

applicable d&b rigging accessories. The Rota clamp allows the

load to be attached to overhead bars or truss with a tube diameter

of up to 70 mm (2.75").

Note: Observe the maximum permitted load of the respective

accessories as indicated in their respective mounting

instructions.

Fitting to Flying adapter/Flying frame

The desired position in the rig as well as the total vertical angle of

the assembly should be defined in advance. The total vertical

angle can be set using the hole grid of the respective flying

adapter or frame.

Proceed as follows:

1. Unlock and remove the ring cotter [1a] of the fixing bolt and

remove the fixing bolt [1b].

2. Attach the clamp to the respective hole of the flying adapter or

frame.

3. Insert the fixing bolt [1b] and secure the bolt with the ring

cotter [1a].

4. Recheck your work and ensure the ring cotter [1a] is properly

fitted and locked.