Ambient Technologies RCMT Manuale di installazione e istruzioni per l'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Telecomando Ambient Technologies RCMT. Ambient Technologies RCMT 7. Manual on/off remote control with timer
Anche per Ambient Technologies RCMT: Istruzioni per l'installazione e il funzionamento (2 pagine)
Stampa la pagina
Optional 6 Hour Shutdown
1. The receiver comes preset from the factory with a 6 hour shutdown from its last ON operation. This is done to
prevent the appliance from continuing to run if unattended.
2. You may disable this feature if you wish. To disable, change the receiver privacy (DIP) switch #1 ONLY to
the OFF position. Make sure the transmitter privacy (DIP) switches are set the same. Follow the instructions
on Setting Privacy (DIP) Switch on Receiver & Transmitter discussed earler in this manual.
3. By disabling this feature, your appliance may continue to run unattended.
Slide Switch
1. ON position: the system will remain on until the slide switch is placed in the OFF or RS position.
2. RS position: the system will only operate if the remote receiver detects a signal from the transmitter.
3. OFF position: the system is off. The slide switch should be placed in the OFF position if you will be away for
an extended period of time. If the remote receiver is mounted out of children's reach, the OFF position also
functions as a safety device by both turning the system off and rendering the receiver inoperable.
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1. Connect the wiring terminal to the appliance. Refer to the appropriate Homeowner's Manual for proper
wiring connections.
2. Light your gas appliance following the lighting instructions that came with the appliance. Confirm that the
pilot light is on; it must be in operation for the remote control to operate the main gas valve. Appliance pilot
control knob must be in the ON position. Appliance ON/OFF switch must be in OFF position.
3. Slide the 3 position button on the remote receiver to the ON position. The main gas flame should ignite.
4. Slide the button to OFF. The flame should extinguish (the pilot light will remain on).
5. Slide the button to RS (the center position), then press the ON button on the transmitter to turn the system to
ON. The main gas flame should ignite.
6. Press the OFF button on the transmitter to turn the system off. The flame should extinguish (the pilot light
will remain on).
Symptom
1. LED light on the
receiver blinking
2. Appliance does not
come on after pressing
the ON button in
transmitter
3. Receiver cannot detect
signal.
50D0103 RCMT Rel 1 02/10/2006
TROUBLESHOOTING
Causes
1. Low Battery
1. Wiring / Electrical Connections
2. Privacy (DIP) switch setting on
transmitter does not match receiver
3. Distance between the transmitter
and receiver is more than 30 feet
1. Receiver is installed in an
enclosure.
Page 6 of 7
Action
1. Replace batteries. Change batteries every 6
months.
2. Check battery installation and replace
batteries.
1. Slide the switch to ON, if appliance comes
ON, wiring is not the cause.
2. If appliance does not come on, check wiring
connections.
1. Make sure the transmitter and receiver have
the same DIP switch settings.
1. Make sure the operating distance is less
than 30 feet
1. Make sure the receiver is not located inside
to tight of an enclosure.
Ambient Technologies
A Division Of Monessen Hearth Systems