AMBILIFE AMBILIFE Manuale operativo - Pagina 6

Sfoglia online o scarica il pdf Manuale operativo per Pulitore d'aria AMBILIFE AMBILIFE. AMBILIFE AMBILIFE 12. Photocatalytic air purifier

6.1.
Unpack the Appliance and check its completeness according to provisions of Chapter 4
(please refer to Table 2 at page 5) of this operation manual.
6.2.
Carry out visual inspection of the Appliance for possible damages, which may take place
during its transportation.
6.3.
If the Appliance has been stored in the cold room or transported at temperatures below
the freezing point, before switching it on the Appliance should be kept at a room temperature for at
least two hours in order to ensure condensate evaporation.
6.4.
It is recommended that Appliance should be installed on the horizontal or vertical surface
(please refer to Fig. 2 at page 7). Special holes are provided on the rear wall of the Appliance for
vertical mounting (please refer to Fig. 3 at page 7). It is not recommended to install Appliance near
the window and door openings, as well as less than 0.3 m distance from the walls or partitions.
7.1. Put power cord of the Appliance into 220 V socket.
In case of L-10016 models: After putting power cord into 220 V socket you will hear a long beep
and the Appliance will go into the standby mode (LED indicator flashes green).
Switch "I-0-II" in these models cannot be fixed. In order to switch on or off the Appliance you
should press «I» key. When the Appliance enters "Operation" mode, it will produce beep sound
(LED indicator will continuously light green).
LED indicator
Рower switch
Рower cord

7. Operation procedure

6
Figure 2
Figure 3